3-Input Video MUX Cable

The circuit diagram shows a low-cost 3-input video MUX cable driver. In this circuit, the amplifier is loaded by the sum of RF and RG of each disabled amplifier. Resistor values have been chosen to keep the total back termination at 75 ? While maintaining a gain of 1 at the 75-? Load. The switching time between any two channels is approximately 32 ns when both enable pins are driven.

3-Input Video MUX Cable

When designing a circuit board for this cable driver, care should be taken to minimize trace lengths at the inverting input. The ground plane should also be pulled away from RF and RG on both sides of the board to minimize stray capacitance. Current consumption of the cable driver is a modest 8mA.