The AN7147 Dual lima.Tiga-watt Audio Power Amplifier from Panasonic is listed as a ?Replacement type? So hopefully will be around for some time to come. Together with some extra components, it can represent a simple surround-sound system requiring no opamps or a negative voltage supply. As shown by the circuit diagram the basic stereo amplifier is changed into a surround-sound system by a trick called ?Adding feedback from the opposite channel?. When surround sound is required, the negative feedback signals supplied by C13-R3 and C12-R4 are fed to the inputs of the ?Other? Amplifier. The resulting phase difference causes the surround effect. If surround sound is not required, the effect can be disabled by pressing push-button S1.
5.3W Amplifier With Surround System Circuit Diagram:
This causes the bistable built around IC2.A and IC2.B to toggle and drive transistors T1 and T2 such that the above mentioned negative feedback signals are effectively shunted to ground. A high-efficiency LED and a tiga.3-k? Series hambatan (R14) should be used to make sure the maximum hasil current of the CMOS 4001 device is not exceeded. The amplifier should not be loaded with impedance's smaller than 3?. The AN7147 will typically supply up to 4.3 watts into 4 ?. The SIL-12 case needs to be cooled wit a small heatsink of about 6 K/W or better. The quiescent current is modest at just 19 mA.
