Electronic Telephone Ringer Circuit Diagram

How to Build a Electronic Telephone Ringer. This circuit produces a ringing sound similar to that made by more recent telephones. It consists of three almost identical oscillators connected in a chain, each generating a squarewave signal. The frequency of each oscillator depends on the RC combination: R4 and C1 around IC1.A, R8 and C2 around IC1.B and R12 and C3 around IC3.C.

Electronic Telephone Ringer Circuit Diagram

The pairs of 100 k?Resistors divide the asym-metric power supply voltage (between 5 V and 30 V) so that, in conjunction with the 100 k?Feedback resistors (R3, R7 and R11) either one third or two thirds of the supply voltage will be present at the non-inverting inputs to the opamps. The voltage across the capacitor therefore oscillates in a triangle wave between these two values.

Electronic Telephone Ringer Circuit Diagram:


The first oscillator is free-running at a frequency of approximately 1/3 Hz. Only when its output is high, and D1 stops conducting, can the second oscillator run. The frequency of the second oscillator is about 13 Hz, and optional LED D3 flashes when it is running. When the output of the second oscillator is low, the third is allowed to run. The frequency of the third oscillator is around 1 kHz, and this is the tone that is produced. The second oscillator is not absolutely necessary:

its function is just to add a little modulation to the 1 kHz tone. A piezo sounder is connected to the hasil of the third oscillator to convert the electrical signal into an acoustic one. The current consumption of the circuit is just under 1 mA with a 5V power supply, rising to about 1.65 mA with a supply volt-age of 15 V.